Drive Belt - Husqvarna K 1 PACE Workshop Manual

3. Loosen the screws. Remove the blade guard, seals,
spacer and screen rings.
4. Remove the wear protection.
5. Assemble in the opposite sequence.
28 - Repair instructions

8.7 Drive belt

8.7.1 To remove the drive belt
1. Remove the belt guard. Refer to
on page 15 .
2. Put the belt tool on top of the front pulley. Use a
wrench to pull the drive belt off the pulley.
8.7.2 To install the drive belt
1. Put the drive belt around the rear pulley.
2. Put the belt assembly tool on top of the front pulley.
3. Turn the front pulley clockwise with the combination
wrench. At the same time, push the drive belt onto
the pulley.
4. Attach the belt guard. Refer to
page 15 .
Product overview
Product overview on
1597 - 003 - 05.07.2023