List Setup - UNI-T UDP6722 User Manual

User's Manual
7. Setup
Press [Delayer] two times to enter setup page. The page can set other setup for power output.
< Setup> Page

7. List Setup

List mode is used to set the voltage and current value and output time for every steps. To complete
the various kinds of output changing through the combination of multiple steps. The list mode supports the
maximum setting of 200 steps, and the instrument supports the storage of 40 list files. User can save the
file into USB or recall the file from USB after USB inserts in the instrument.
Press [List] key can step through <Measure>, <List>, and stay at <List> page. Or press the functional key
below the <Measure > page and press [List] key to enter list setup page.
Instruments.uni-trend.com
Figure 7-1
Item Setting
Timer Off, On
Time 0.1-9999.9s
P-out Off, On
Figure 8-1 <List Setup> Basic Parameter Setup
<Setup> Page
Description
The instrument will stop output when it
reach to the set output time. The default
setting is Off.
Time for timing output, the default time is
0.1s.
Whether to output the set parameter after
the instrument boots up. The default setting
is Off.
UDP6722 Programmable DC Power Supply
17 / 32