Table of Contents
Advertisement
B. Connections
1. Connect the cord assembly into the
receptacle.
2. Place the soldering iron in the iron
holder.
3. Plug the power cord into a power
supply. Be sure to ground the unit.
4. Turn the power switch to on.
The temperature is preset at 750°F at
the factory.
The heater lamp flickers when the
temperature has stabilized.
5. Press the * button to display the preset
temperature. It will be display for two
seconds.
C. Set the Temperature
CAUTION! Be sure to insert the correct end of the card into the card slot. While setting
the temperature, the power supply to heating element is off.
Example:
°F to
750
660
1
.
7 5 0
↓
7 5 0
2
.
↓
6 5 0
↓
Press
°F
Insert the card
button once
1. Insert the card into the card slot in the station.
The left-most digit (the 100's digit) in the
display will flash. This indicates that the
station is in temperature setting mode and that
the 100's digit can be adjusted.
2. Select the desired value for 100's digit. Using
the "up" or "down" button will change
displayed value as follows.
Press the "*" button when the desired value is
displayed.
This will cause the middle digit (the 10's
digit) in the display begin flashing.
3
Advertisement
Table of Contents
