Related Manuals for Aktakom ASE-1115
Summary of Contents for Aktakom ASE-1115
- Page 1 User’s Manual SOLDERING STATION ASE-1115 Thank you for choosing AKTAKOM soldering station. www.tmatlantic.com...
- Page 2 1. Description ASE-1115 Soldering Station designed for lead free soldering especially. Heating up from the room temperature to 350℃ in 30 seconds. This tool is used in the fields of electronic research, teaching and production, especially in the repairing and soldering on the electronic appliances and communication equipments.
- Page 3 3. Operating Instruction 3.1 Place the soldering iron in the holder separately. Then connect the plug to the receptacle on the station and turn clockwise to tighten the plug nut. Check that the power supply is corresponding to the specification on the type plate and the power switch is on the “OFF”...
- Page 4 temperature② in ℉, and vice versa. system will display the actual temperature① and setting ④When the actual temperature on the soldering tip is less than the set-point, “HEAT ON” will display and make the soldering tip heating up. ⑤When the absolute offset is more than ±10℃ between the actual temperature and the set-point on the soldering tip or the nozzle, “WAIT”...
- Page 5 4. Safety Instruction • The manufacturer assumes no liability for uses other than those described in the operating instructions or for unauthorized alterations. • The operating instructions and cautions should be read carefully and kept in an easily visible location in the vicinity of the control system.
- Page 6 o be careful when using the appliance in places where there are combustible material; o do not apply to the same place for a long time; o do not use in presence of an explosive atmosphere; o be aware heat may be conducted to combustible materials that out of sight;...
- Page 7 5.4 Maintenance Before further use, safety devices or slightly damaged parts must be carefully checked for error-free and intended operation. Inspect moving parts for error-free operation and that they don’t bind, or whether any parts are damaged. Damaged safety devices and parts must be repaired or replaced by a qualified technician, so long as nothing else is indicated in the operation manual.
- Page 8 Visit www.tmatlantic.com for more information www.tmatlantic.com...
Need help?
Do you have a question about the ASE-1115 and is the answer not in the manual?
Questions and answers