ETC ColorSource Spot VXT Installation Manual page 7

ETC Installation Guide
ColorSource Spot VXT
Multiverse Settings
Setting
Universe
Multiverse
Multiverse
SHoW ID
Multiverse
SHoW Key
Connection Status
The indicator light next to the NFC tag
shows the current status of DMX data:
• On solid: Connected to a
transmitter and receiving data.
The solid light turns off after
30 seconds.
• Flashing steadily: Not receiving
DMX data.
Set the DMX Address and
DMX Control Mode
Set the DMX address and DMX control mode using RDM or the Set Light
app. You can set the DMX control mode for the fixture to one of five
available mode options.
• Standard: Intensity, red, green, blue, strobe, and fan. This is the
default mode.
• Direct: Direct emitter control of intensity, red, green, blue, indigo,
lime, strobe, and fan.
• 1-channel: Controls the intensity of preset 1 (defaults to 3200 K
White).
• RGB: Red, green, and blue.
• 5-channel: 5-channel mode (intensity, red, green, blue, and
strobe). This mode uses the legacy white point (5400 K) and strobe
function from the original ColorSource family.
ColorSource Spot VXT
Values
001–999
(Default = 001)
• Off (Default)
• On
• 24100–24359
(Default = 24100)
• 101–204
(NEO SHoW IDs)
000–500
(Default = 000)
Description
Set the Universe value.
Turns on or turns off power to the
Multiverse radio.
Set the value of the SHoW ID. This value
must match the SHoW ID value on the
Multiverse transmitting device.
Set the SHoW Key value. This value must
match the SHoW Key value on the
Multiverse transmitting device.
Indicator light
flashes when
DMX is lost
Page 7 of 16 ETC