Riello RS5 TL Installation, Use And Maintenance Instructions page 36

Forced draught gas burners
Table of Contents

Advertisement

Available languages

Available languages

1.
BURNER DESCRIPTION
One stage gas burner.
The burner meets protection level of IP X0D (IP 40), EN 60529.
CE marking according to Gas Appliance directive 90/396/EEC; PIN 0085BM0114.
According to directives: EMC 89/336/EEC, Low Voltage 73/23/EEC and Machines 98/37/EEC.
Gas train according to EN 676.
The burner is approved for intermittent operation as per Directive EN 676.
Fig. 1
4
1
D7110
1 – Air pressure switch
2 – 6 pole socket for gas train
3 – Control box with 7 pole socket
4 – Reset button with lock-out lamp
5 – Head holder assembly
1.1 BURNER EQUIPMENT
Flange with insulating gasket . . . . . No. 1
Screw and nut for flange . . . . . . . . . No. 1
Remote reset connection . . . . . . . . No. 1
1.2 ACCESSORIES
SOFTWARE DIAGNOSTIC KIT
A special kit is available that, by an optical link to a PC, shows the burner life together with operating hours, type
and number of failures, serial number, etc.
To visualise the diagnostics proceed as follows:
Connect the kit supplied separately to the control box socket.
Reading of the information begins when the software programme included in the kit starts.
REMOTE RESET KIT
The burner has a remote reset kit (RS) consisting of a connection and a push-button operating at a
distance of 20 metres max.
In order to install it remove the protective lock-out installed at the factory and insert the lock-out supplied
with the burner (see electrical diagram on page 7).
MULTIBLOC ROTATION KIT
There is a special kit available that can be used to install the burner turned 180°, as illustrated on page 5 in
position 5 in the section entitled "3.1 WORKING POSITION". This kit is designed to ensure the gas train
valve works properly. The kit must be installed in conformity with laws and local regulations.
3095
7
3
10
2
6 – Pressure test point
7 – Flange with insulating gasket
8 – Air damper adjustment assembly
9 – Servomotor
10 – Motor
Screws and nuts for flange to be fixed to boiler . . . No. 4
7 pin plug . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . No. 1
2
GB
5
6
8
9

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

Rs5920t1

Table of Contents