Controls And Features - Monogram ZIBI240HII Owner's Manual

CONTROLS AND FEATURES

Temperature Controls
The temperature display shows the actual temperature
of the fresh-food refrigerator. The actual temperature
may vary slightly from the set temperature based on
factors such as door openings, amount of food and room
temperature.
To change the temperature setting, press the + or –
pads until you reach the desired set temperature. After 5
seconds, the display will return to the actual temperature.
After making adjustments, allow 12 to 24 hours for the
fresh-food refrigerator to reach the temperature you have
set and before making any further adjustments.
Temperature Settings
Minimum: 34°F (1.1°C)
Maximum: 45°F (7.2°C)
NOTE: The icemaker temperature is not displayed.
Child Control Lockout
This child control lockout feature prevents unwanted
changes to your temperature settings.
Unit ON/OFF
This pad stops cooling in the bar refrigerator with icemaker,
turns off the temperature controls and removes power to
the light circuit.
Glass Shelves
Tempered glass shelves in the bar refrigerator with
icemaker are removable for easy cleaning or for storing
larger items.
To remove a shelf, open the door completely to avoid
potential damage to the gasket. Lift up on the back of the
shelf slightly. Tilt the shelf to one side at an angle while
pulling forward.
Appearance may vary
8
POWER
ON/OFF
HOLD 3 SEC
To remove, lift up on the back of
the shelf
After the desired temperature is set, the temperature can
be locked. To lock, press both the + and – pads at the
same time for five seconds. To unlock, press both + and –
pads for five seconds.
NOTE: The icemaker is on a separate ON/OFF switch. To
remove power from the icemaker See Automatic Icemaker
section.
Press this pad for a minimum of 3 seconds to turn the bar
refrigerator with icemaker on or off, or unplug the unit for
long vacations or absences, or when cleaning the unit or
changing the light bulb.
To replace a shelf, open the door completely to avoid
potential damage to the gasket. Tilt the shelf to one side
at an angle and slide toward the back wall, placing one
side onto the shelf support. Place the other side onto
the opposite shelf support. Ensure rear locking tabs are
engaged. When installed properly, the shelf will not slide
forward when gently pulled.
Tilt the shelf at an angle while
removing or replacing
Place in slots when replacing the
shelf
49-1000735