Controls And Features - Monogram ZIBI240 Owner's Manual

Temperature The temperature display shows the actual
temperature of the bar refrigerator with
control
icemaker. The actual temperature may vary
slightly from the set temperature based on
factors such as door openings, amount of
food and room temperature.
To change the temperature setting,
press the WARMER or COLDER pads until
you reach the desired set temperature.
After 5 seconds, the display will return to
the actual temperature.
After making adjustments, allow 12 to 24
hours for the bar refrigerator with icemaker
to reach the temperature you have set and
before making any further adjustments.
Child control
lockout
Unit ON/OFF
This pad stops cooling in the bar refrigerator
with icemaker, turns off the temperature
controls and removes power to the light circuit.
NOTE: The icemaker is on a separate on/off
switch. To remove power from the icemaker
See Automatic Icemaker section.
Press this pad for a minimum of 3 seconds
to turn the bar refrigerator with icemaker on
or off, or unplug the unit for long vacations
or absences, or when cleaning the unit or
changing the light bulb.
Glass Tempered glass shelves in the bar
refrigerator with icemaker are removable for
shelves
easy cleaning or for storing larger items.
To remove a shelf, open the door
completely to avoid potential damage to
the gasket. Lift up on the back of the shelf
slightly. Tilt the shelf to one side at an angle
while pulling forward.
8
This child control lockout feature prevents
unwanted changes to your temperature
settings.
Appearance may vary
To remove, lift up on the back of the shelf

Controls and Features

NOTE: The icemaker temperature is not displayed.
Temperature Settings
Minimum: 34°F (1.1°C)
Maximum: 45°F (7.2°C)
After the desired temperature is set, the
temperature can be locked. To lock, press
both the + and – pads at the same time for
five seconds. To unlock, press both + and –
pads for five seconds.
To replace a shelf, open the door completely
to avoid potential damage to the gasket.
Tilt the shelf to one side at an angle and
slide toward the back wall, placing one side
onto the shelf support. Place the other side
onto the opposite shelf support. Ensure rear
locking tabs are engaged. When installed
properly, the shelf will not slide forward
when gently pulled.
Tilt the shelf at an angle while removing
or replacing
Bar Refrigerator with Icemaker
Place in slots when replacing the shelf