Adjusting The Video Channel - Sharp VC-H726X Operation Manual

To view the output of your VCR on the television screen, you must select an unused channel on your TV and
tune it to the output of your VCR (factory preset to UHF channel 37).
O
Turn on the TV, select the AV channel or an unused channel on the TV and turn on the VCR.
© Load
a
prerecorded tape (not supplied) into the
VCR. ........
© If the erasure protection tab on the tape is removed, the VCR will automatically playback the tape.
Otherwise press
PLAY/
x
2.
0
Tune the selected channel on the TV until the picture from the VCR is displayed on the TV screen. (This TV
channel must be selected each time the VCR is used.)_
• If picture interference appears on the TV screen in step © above, you can change the video channel
(RF
output channel from the VCR) with the following procedure. (If UHF channel 37 is an active broadcast channel
in your area, manually select a different channel (UHF 28 to UHF 69) (see below) and then retune your TV as
(A)
Press^
STANDBY on the VCR or the remote control. The VCR enters POWER STANDBY mode.
(Bf Keep pressing MENU for more than two seconds to light up the -InTf on the VCR display,
(C) Press CHANNEL a/T on the VCR or
A/T
of %► on the remote control to manually select an unused channel
for use as the video channel, then press SET.
(D) Repeat steps © to © above using the newly selected video channel.