Connections; Adjusting The Video Channel - Sharp VC-H600X Operation Manual

UC
onnections
o
Q
o
Disconnecting
TV
Cable
-.
-. ,,
Disconnect the aerral cable from the back of
-->:~.-
your TV set
T
&
Connecting Aerial Cable to VCR
Connect the aerial cable to the ANTENNA IN
terminal of your VCR
-a
1,
\ 5;gl ' ;j o
j mu—
ANTENNA IN
Connecting VCR to TV
connect th= supplied coaxial cable to the RF OUT terminal of the VCR, Plug the other end
Into your
TV'S
ANTENNA IN terminal.
TV back panel
ANTENNA IN
ANTENNA IN
~ Adjusting the Video Channel
To view the output of your VCR on the television screen you must select an unused
and tune II to the output of your VCR (factory preset to UHF channel 37)
#
NOTE:
TUNE THE TV NOT THE VCR
~
select an unused channel on your TV and press the OPERATE button on
ihe
power
~ set the TEST SIG switch to ON
@ Adjus? the tuning of the selectea TV channei until the test pattern
your TV screen.
@ SeI the TEST SIG switch to OFF
d
NOTE:
I; Interference or a beat pattern Is receIved wnen the tes~pattern Is tuned In, US(
channel on your TV
VCR to turn on the
two vertical bars) appears on
converter output channel adjuster to change the VCR output cnannel and then retune your TL' as above
8