Table of Contents
Advertisement
El
Connections
0
0
0
To view the output of your VCR on the television
screen, you must select an unused channel
on your T\
and tune it to the output of your VCR (factory preset to UHF channel
37).
0
Q
0
0
A
0
0
a
Make sure that both units (TV and VCR) are connected
(power cord) to the power point.
Turn on your TV.
Select an unused channel
on your TV.
Set
the power on the VCR to off. (If the VCR is ON, press the
OPERATE
button
to turn off th
power.)
Keep pressing
the
MENU
button
for more than two seconds
to light up the "VCR" on the VC
display.
Adjust the tuning
of the selected
TV channel
until the MENU pattern
appears
on your TV screer
(Refer to your TV Operation
Manual for tuning procedures.)
Disconnecting TV Cable
Disconnect
the
aerial
cable from the back of
your TV set.
Connecting Aerial Cable to VCR
Connect
the
aerial cable to the ANTENNA IN
terminal
of your VCR.
0
ANTENNA
IN
Connecting VCR to TV
Connect
the supplied
coaxial cable to the RF OUT terminal of the VCR. Plug the other end into you
TV's
ANTENNA IN
terminal.
RF OUT
TV back panel
ANTENNA
IN
ANTENNA
IN
Adjusting the Video Channel
l
If
interference or a beat pattern is received wnen the test pattern is tuned
in, use a small screwdriver
to turn the F
converter
output channel adjuster to change the VCR output channel,
and then retune your TV as above.
0
l
8
Advertisement
Table of Contents
