Advertisement
Table of Contents
EEI-2650
TABLE
Thank you for purchasing the MODWAY TABLE！
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the table, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approx assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or the instruction until you have checked all the components and
hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
environmentally friendly way.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that has been provided.
6.Please keep all fitting out of reach of children.
Component:
5
1
Table Top
x1
4
Bottom Rail
x1
Customer Service 908-368-1025︱www.modwayfurniture.com
1
6
2
2
Table Leg
5
Support Rail
Hardware:
A
B
C
D
3
4
x2
x4
Bolt M8x35mm
Bolt M8x50mm
Flat Washer M8
Allen Wrench M5
5
6
2
3
Top Rail
6
Leaf
Page 1 of 3
x2
x9
x11
x1
x1
x2
Advertisement
Table of Contents
Related Manuals for modway EEI-2650
Summary of Contents for modway EEI-2650
- Page 1 EEI-2650 TABLE Thank you for purchasing the MODWAY TABLE！ Before you start, here is some helpful advice: 1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step instructions. 2.Owing to the size and weight of the table, we recommend that it is assembled by two adults, on a carpeted or padded area, in the room that it is intended for.
- Page 2 EEI-2650 TABLE STEP 1: Please put Table Legs (2), Top Rail (3) and Bottom Rail (4) upside down on a carpeted or padded area. Position Bottom Rail (3) and Top Rail (3) to the bottom of Post (3) as shown.
- Page 3 EEI-2650 TABLE STEP 3: Carefully turn over the assembled table. If your want to use Leafs (6), please fully extend Support Rails (5) and put Leafs (6) to Support Rails (5) as shown. Insert the removed 4 pieces of Bolts from step 2 into the pre-drilled holes on bottom of Table Top (1) through the pre-drilled holes on bottom of Support Rail (5).
Need help?
Do you have a question about the EEI-2650 and is the answer not in the manual?
Questions and answers