Advertisement
Table of Contents
EEI-2651
TABLE
Thank you for purchasing the MODWAY TABLE！
Before you start, here is some helpful advice:
We suggest you spend a short time reading through this leaflet and then follow the simple step by step
1.
instructions.
Owing to the size and weight of the table, we recommend that it is assembled by two adults, on a carpeted or
2.
padded area, in the room that it is intended for. Approx assembly time: 30 minutes.
Please do not use any tools other than those provided or recommended in these instructions.
3.
Please do not throw away any of the packaging or the instruction until you have checked all the components and
4.
hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
environmentally friendly way.
Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
5.
components from time to time, so please save the tools that has been provided.
Please keep all fitting out of reach of children.
6.
Component:
5
4
1
Table Top
x1
4
Support Rail
x4
Customer Service 908-368-1025︱www.modwayfurniture.com
1
2
2
Table Leg
Hardware:
A
B
C
D
2
3
x2
Bolt M8x40mm
x6
Bolt M8x70mm
x8
Flat Washer M8
x14
Allen Wrench M5
x1
4
5
3
Table Across
x1
5
Leaf
x2
Page 1 of 3
Advertisement
Table of Contents
Related Manuals for modway EEI-2651
Summary of Contents for modway EEI-2651
- Page 1 EEI-2651 TABLE Thank you for purchasing the MODWAY TABLE！ Before you start, here is some helpful advice: We suggest you spend a short time reading through this leaflet and then follow the simple step by step instructions. Owing to the size and weight of the table, we recommend that it is assembled by two adults, on a carpeted or padded area, in the room that it is intended for.
- Page 2 EEI-2651 TABLE STEP 1: Please put Table Legs (2), Table Across (3) upside down on a carpeted or padded area. Position Table Across (3) to Table Legs (2) as shown. Insert 2 pieces of Bolt (A) with 2 pieces of Flat Washer (C) into the pre-drilled holes on Table legs (2) through the pre-drilled holes on Table Across (3).
- Page 3 EEI-2651 TABLE STEP 3: Carefully turn over the assembled table. If your want to use Leafs (5), please fully extend Support Rails (4) and put Leafs (5) to Support Rails (4) as shown. Insert the removed 4 pieces of Bolt from step 2 into the pre-drilled holes on bottom of Table Top (1) through the pre-drilled holes on bottom of Support Rail (4).
Need help?
Do you have a question about the EEI-2651 and is the answer not in the manual?
Questions and answers