Advertisement
INSTALLATION GUIDE
Panel Preparation
NOTE
Panel Preparation
PCB: 3 BUTTON + START
PCB:
4 BUTTON
+
START
STIP 12
Panel Preparation
Place the three orfour button drive-train/
ignition control trim (777 6 / 7777) into the face
panel (Based on vehicle model type).
NOTE:
Image
image of panel on right is based on three button.
STEP
1
S
Panel
Preparation
Place the OEM drive-train/ ignition control buttons
(retained
in Step 11) into the trim from Step
12.
Next, place the three provided PCB spacers indicated
by arrows on top of button controls.
STEP 14
Panel Preparation
Place the rubber pad from the OEM
drive-train controls onto the back of the
buttons being cautious not to knock over
the spacers
placed
on previous
step.
NOTE: 4-Button displayed, follow same
procedure for 3-button
STEP 15
Panel Preparation
.
Carefully align the circuit board over the rubber
pad, then continue to
the next
step.
()2021 SCOSCHE
INDUSTRIES, INC.
5
3-Button
displayed,
follow same procedure
for 4-button
ITCFDOSAB
10/21
Advertisement
