Sony CCD-VX3 Operation Manual page 38

TE Ei wae See ak |
Shes
Adjusting the White Balance
Locking the White Balance Setting (One-Push White Balance Mode)
the e& button. The nf indicator flashes rapidly. When the white balance has been adjusted and stored in the
memory. the indicator stops flashing.
Notes on the 8 indicator in the viewfinder
e The state of the indicator shows as follows:
Stow flashing: White balance is not adjusted.
Fast flashing: White balance is being adjusted after pressing the e& button.
Lights up: White balance has been adjusted.
@ When the o& indicator remains flashing even if you press the nf button. shoot in automatic white balance
mode. Press WHT BAL until no indicator appears in the viewfinder.
Shooting when the lighting condition changes
¢ When the lighting condition has changed, readjust the white balance with the o& button during recording
standby mode. (This button does not function during recording.)
« When you adjust the aperture and shutter speed manually, and move from indoors to outdoors or vice-versa.
slide the AUTO LOCK switch up (green position), then slide it down to the center position again.
e When you move from indoors to outdoors or vice-versa, or detach the battery for replacement while shooting
in automatic white balance mode. point the camcorder to a white subject about 10 seconds before you start
recording.