Display Assembly - HP ZBook Studio G5 Maintenance And Service Manual

Display assembly

NOTE: The Dream Color display assembly and touch display assemblies are spared only as whole unit
assemblies. Non-touch display assemblies are spared at the subcomponent level only. For non-touch display
assembly spare part information, see the individual removal subsections.
Description
15.6-in, UHD, UWVA, Dream Color display assembly not equipped with a camera
15.6-in, UHD, UWVA, Dream Color display assembly equipped with a camera
To remove the display assembly and access display assembly subcomponents, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
Remove the display assembly:
1. Remove the two Phillips M2.0×3.0 screws (1) from the display cable connector bracket.
2. Remove the bracket (2), and then disconnect the display cable from the system board (3).
3. Disconnect the antennas from the WLAN antenna posts (4).
4. Disconnect the camera cable from the system board (5).
Brackets are available in the Bracket Kit using spare part number L28674-001.
5. Remove the five Phillips M2.5×4.5 screws (1) that secure the display to the computer.
Bottom cover on page
Battery on page 35).
33).
Component replacement procedures
Spare part number
L28663-001
L28664-001
67