Table of Contents
Advertisement
level to perform a measurement. You can restrict the range of impedances which will be considered
min. imp.
normal by setting
impedance may depart dramatically from the rated impedance due to variations in impedance for
different frequencies for a given loudspeaker. If the measured impedance should fall outside this
range, then a Check incident will be raised. See
Stereo Linking
Linking may be changed in the gain/delay view of the System Engineer panel. Each 'strip' contains a
stereo link button. Stereo linking is available between DSP Drive Modules A & B and between C & D
(and between E & F and between G and H for the 88C model). When stereo linked, adjusting a
parameter in either of the stereo linked Drive Modules will then change the other linked Drive Module
to the same value.
Note: Stereo linking will only work when the linked Drive Modules are of equal size.
Note: Stereo Linking state is not stored in Presets (but is stored in Snapshots)
IP Address
This may be viewed and edited in the tools>networking page of the System Engineer panel.
current IP address
The
using.
The Ethernet IP address may be automatic "Auto" or may be a fixed static value "Static" as
IP mode
determined by the
WARNING – Do NOT use Static mode unless your IT system specifically requires it. Auto mode
should always be used where possible since in this mode, the Device can always be 'discovered'
by the System Engineer application. When in Static mode, the IP Address will flash on the Home
screen.
If you cannot communicate with the device and the IP address of the device is in an unknown
state, you can restore it to Auto mode by pressing and holding the recessed button on the rear of
the device for about 10 seconds.
static IP address
The
will not take effect until you click apply. The new IP address will then be checked to ensure it is
'legal'. If it is legal, the device will be instructed to change to this IP address. If you were online to the
device in static IP mode, it may be necessary to go offline, then back online again.
Also see
Ethernet Configurations
Store Snapshot
The setup view of the System Engineer panel has a
of the device to be stored into the device. A snapshot can also be recalled (activated) from here.
Snapshot may also be recalled from an Aux port, or by using the
Also see
Snapshots
max. imp.
and
cannot be edited; it simply shows you what IP address the device is currently
button.
may be edited by typing numerical values into the four boxes. The new value
.
,
Aux Port
and
Tipi Third Party Interface
to values other than "Any". Please note that the measured
Incident Reporting
setup snapshots
section. This allows a Snapshot
Tipi
third party interface protocol.
29
Advertisement
Table of Contents
