Table of Contents
Advertisement
These concepts are depicted in the System Engineer application as in the following example of a 2-
way Module:
Snapshot
A
is a device-wide representation of most of the settings in the device. This is represented
as eight Input Component numbers, or eight Output Component numbers, plus a number of machine-
centric settings such as routing and Input/Output Analogue/Digital selection etc.
Device
Settings
Drive Module Presets
not
Presets do
change the settings device-wide. Rather, recalling a Module Preset creates a Drive
Module by 'consuming' a number of consecutive outputs and setting up routing between the Input the
preset was recalled on and those outputs. The parameters in that Drive Module are then set according
to the parameters in the components in the Module Preset.
Note however, that modules with non-consecutive outputs can be created by manually manipulating
the routing, and then recalling
Snapshot
then be stored in a
Note: When a Module Preset Recall consumes outputs to construct a module, it treats a pair of
Bridged outputs as a single channel, so recalling a 2-way Module Preset will consume 3 output
channels if a Bridged pair is encountered. See
Note: DSP inputs are not the same as physical inputs. The 44/88 C Series has four audio inputs
and four DSP inputs. This is a matrix mixing system where any physical inputs, be they analogue,
AES3 or networked audio feeds, can drive any number of DSP inputs.
Component Presets
A Component Preset represents the processing for just one output. Any part of a Module Preset may
be recalled to any one output. A Drive Module comprised of parameters which have been recalled to
its outputs using Component Preset Recalls can then be saved into another
the outputs remain consecutive (i.e. you have not changed the routing manually). If the routing has
been changed manually, then the whole arrangement may be saved into a
Snapshots
and
Recalling
Input A component number
Input B component number
Input C component number
Input D component number
Input E component number
Input F component number
Input G component number
Input H component number
Component Presets
. Such a Module cannot be saved in a Module Preset.
Components.
Output 1 component number
Output 2 component number
Output 3 component number
Output 4 component number
Output 5 component number
Output 6 component number
Output 7 component number
Output 8 component number
to the individual outputs. The resulting system can
Bridge Mode
Module Preset
provided
Snapshot
Also see
.
22
Advertisement
Table of Contents
