Specifications; Intended Use - Makita DFL020F Instruction Manual

ENGLISH (Original instructions)

SPECIFICATIONS

Model:
Fastening torque
Square drive
Drive shank
Country specific
*1
No load speed (RPM)
Rated voltage
Overall length
(Depending on the battery)
Net weight
Applicable USB cable
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-
est combination, according to EPTA-Procedure 01/2014, are shown in the table.
*1
• No load speed is adjustable with exclusive application.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of residence.
WARNING:
Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.

Intended use

The tool is intended for screw driving in wood, metal
and plastic.
Noise
The typical A-weighted noise level determined accord-
ing to EN62841-2-2:
Model DFL020F
Sound pressure level (L
pA
Uncertainty (K) : 3 dB(A)
Model DFL063F
Sound pressure level (L
pA
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB (A).
NOTE: The declared noise emission value(s) has
been measured in accordance with a standard test
method and may be used for comparing one tool with
another.
NOTE: The declared noise emission value(s)
may also be used in a preliminary assessment of
exposure.
Hard joint
Soft joint
with BL1815N
with BL1860B
) : 71 dB (A)
) : 71 dB (A)
DFL020F
0.5 - 2 N•m
0.5 - 2 N•m
1.3 - 1.6 kg
BL1815N / BL1820B / BL1830B / BL1840B / BL1850B / BL1860B
DC18RC / DC18RD / DC18RE / DC18SD / DC18SE / DC18SF /
WARNING:
Wear ear protection.
WARNING:
The noise emission during actual
use of the power tool can differ from the declared val-
ue(s) depending on the ways in which the tool is used
especially what kind of workpiece is processed.
WARNING:
Be sure to identify safety measures
to protect the operator that are based on an estima-
tion of exposure in the actual conditions of use (tak-
ing account of all parts of the operating cycle such
as the times when the tool is switched off and when
it is running idle in addition to the trigger time).
Vibration
The vibration total value (tri-axial vector sum) deter-
mined according to EN62841-2-2:
Model DFL020F
Work mode: screwdriving without impact
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Model DFL063F
Work mode: screwdriving without impact
Vibration emission (a
Uncertainty (K) : 1.5 m/s
4 ENGLISH
DFL063F
1.5 - 6.5 N•m
1.5 - 6.5 N•m
9.5 mm
6.35 mm Hex.
-1
100 - 1,300 min
D.C. 18 V
380 mm
397 mm
1.3 - 1.7 kg
661432-2
DC18SH
2
) : 2.5 m/s or less
h
2
2
) : 2.5 m/s or less
h
2