(tak- ing to EN62841-2-2: ing account of all parts of the operating cycle such Model DFL020F as the times when the tool is switched off and when Sound pressure level (L ) : 71 dB (A) it is running idle in addition to the trigger time).
Make sure there are no electrical cables, water NOTE: The declared vibration total value(s) has been pipes, gas pipes etc. that could cause a hazard measured in accordance with a standard test method if damaged by use of the tool. and may be used for comparing one tool with another.
It will CAUTION: Do not install the battery cartridge also void the Makita warranty for the Makita tool and forcibly. If the cartridge does not slide in easily, it is charger. not being inserted correctly.
Page 7
Lighting up the front lamp NOTE: Depending on the conditions of use and the ambient temperature, the indication may differ slightly ► Fig.5: 1. Lamp from the actual capacity. NOTE: The first (far left) indicator lamp will blink when CAUTION: Do not look in the light or see the the battery protection system works.
Page 8
If the the heat because the indicator does not stop, ask cord has broken or other your local Makita Service reasons. Center for repair. Motor failure detection Motor failure has been...
To install the driver bit, pull the sleeve in the direction of the arrow and insert the driver bit into the sleeve as far NOTE: Use the makita genuine USB cable to con- as it will go. nect your computer to the tool. Refer to the section Then release the sleeve to secure the driver bit.
Use the tool within the limits of fastening capacity. If you be performed by Makita Authorized or Factory Service use the tool beyond the limits, the clutch does not work. Centers, always using Makita replacement parts.