Model DFL083F Sound pressure level (L ) : 70 dB(A) or less Read instruction manual. Uncertainty (K) : 3 dB(A) Model DFL125F Sound pressure level (L ) : 70 dB(A) or less Only for EU countries Ni-MH Uncertainty (K) : 3 dB(A)
Model DFL125F Keep children and bystanders away while Work mode: screwdriving without impact operating a power tool. Distractions can cause Vibration emission (a ) : 2.5 m/s or less you to lose control. Uncertainty (K) : 1.5 m/s Electrical Safety Model DFL204F Power tool plugs must match the outlet.
If devices are provided for the connection of Keep handles and grasping surfaces dry, clean dust extraction and collection facilities, ensure and free from oil and grease. Slippery handles and these are connected and properly used. Use of grasping surfaces do not allow for safe handling and dust collection can reduce dust-related hazards.
Always secure workpiece in a vise or similar causing fires, personal injury and damage. It will also hold-down device. void the Makita warranty for the Makita tool and charger. SAVE THESE INSTRUCTIONS. Tips for maintaining maximum WARNING: DO NOT let comfort or familiarity...
To remove the battery cartridge, slide it from the tool Tool / battery protection system while sliding the button on the front of the cartridge. To install the battery cartridge, align the tongue on the The tool is equipped with a tool/battery protection sys- battery cartridge with the groove in the housing and slip tem.
Page 7
This tool has a reversing switch to change the direction Reversing switch action of rotation. Depress the reversing switch lever from the A side for clockwise rotation or from the B side for coun- terclockwise rotation. When the reversing switch lever is in the neutral posi- tion, the switch trigger cannot be pulled.
Page 8
Motor failure detection Motor failure has been Flickers in red and green A series of short beeps Ask your local Makita detected. At this time, alternatively. Service Center for repair. tool does not work. Double-hitting detection When the operator Lights up in red.
Page 9
► 1 . USB cable 2. USB cover 3. USB port NOTICE: Make sure that the USB cover closed when fastening. NOTE: For the application software, please contact ► 1 . Adjust ring 2. Hole for adjust grip Makita sales representative. 9 ENGLISH...
To 3. Torque remove the socket, simply pull it off depressing the pin on the square drive. For model DFL125F CAUTION: Before operation, make sure that the socket is properly locked onto the square drive.
30° To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should N•m be performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts. 1. Range of fastening capacity 2. Rotation angle 3. Torque OPTIONAL...