Table of Contents
Advertisement
WHOLE HOUSE AUTOMATIC TRANSFER SWITCH - ALL aXis CONTROLLER
SpECIFICATIONS
Model
Service Rating
Enclosure Style
Maximum Amps
Nominal Volts
ETL Listed
Load Management Circuits
Weight
Height
Width
Depth
Technical Specifications
– 22kAIC, no short-time current rating.
– Suitable for use in accordance with the National Electrical Code, NFPA 70.
– Suitable for control of motors, electrical discharge lamps, tungsten filament lamps, and electrical heating equipment, where the sum of
the motor full load ampere ratings and the ampere ratings of the other loads does not exceed the ampere rating of the switch, and the
tungsten load does not exceed 30% of the switch rating.
– Continuous load not to exceed 80% of switch rating.
– Line voltage wiring: Cu or AL, min 60°C, min AWG 1 – max AWG 000, torque to 250 in-lb.
– Signal or Com Wiring: Cu only, min AWG 22 – max AWG 12, torque to 28-32 in-oz.
– All connection lugs are rated AL9CU - 90°C rated
NEMA 3R – This type of enclosed ATS is a weatherproof enclosure and required for exterior installations by code. The enclosure has
knockouts on the bottom and side, and requires water tight connections when installed outside per code. This enclosure can also be used
inside.
102006
102007
200
CSA STD C22.2 No.
UL STD NO. 1008
178.1
MODELS
®
102008
Service Entry Rating
NEMA 3R Outdoor
150
120/240
UL STD NO. 1008
4
43 lbs (19.6 kg)
28 in. (710 mm)
20 in. (507 mm)
8.3 in. (210 mm)
19
SpECIFICATIONS
102009
102010
100
CSA STD C22.2 No.
178.1
Advertisement
Table of Contents
