Table of Contents
Advertisement
(1)
Appropriate gauge checker
(2)
Make the shoulder round
(3)
Depth gauge standard
WARNING
Be sure to round off the front edges to reduce the
chance of kickback or tie-strap breakage. Make sure
every cutter has the same length and edge angles as
illustrated.
22
9.9.6 GEAR CASE
The reduction gears are lubricated by multipurpose,
lithium-based grease in the gear case.
Supply new grease every 25 hours of use, or more
often based on the job condition.
When adding lubricant, use a grease gun to insert
lubricant into the three grease nipples located on the
gear case.
NOTE
When removing and installing the cutting holder (a),
be extra cautious to not allow any dirt and dust to
enter the gear case.
10. STORAGE
Aged fuel is one of major causes of engine starting
failure.
(6)
Before storing the unit, empty the fuel tank and run
the engine until it uses all the fuel left in the fuel line
and or the carburettor.
Store the unit indoor taking necessary measures for
(7)
rust prevention.
Advertisement
Table of Contents
