Zephyr Verona Use, Care And Installation Manual page 11

!
CAUTION: At least two installers are
required due to the weight and size of the
hood.
not tighten all the way. Note: Wood blocking may need
to be added behind the drywall if no studs are present.
Wall anchors may also be used but check local codes
for compliance. Failure to use suitable wall anchors
and screws to hold the weight of the hood could result
in personal injury or damage to the cooking surface or
counter.
previously removed screws.
9. Hang hood onto the mounting screws and hand tighten each
duct cover upwards and secure to duct cover
M3.5 x 8 screws.
* If using hood in recirculating mode you must secure the air diverter
to page 10 for more details.
!
WARNING: Electrical wiring must be done by a qualified person(s) in
accordance with all applicable codes and standards. This range hood must be
properly grounded. Turn off electrical power at service entrance before wiring.
Cable Lock
requirements and codes, purchase and install
appropriate connector if necessary.
11 1/8"
Brackets are
pre-installed
FIG. A
Cable Lock
1
9
14 3/4"
26" min
1
2
2
3
Motor Housing
FIG. B