Adjusting The Phase - Sony SVO-5800 Operating Instructions Manual

Using the Unit in a System
Adjusting the Phase
2 Press the B channel button on the vectorscope.
The black burst signal from the switcher is displayed.
3 Adjust the HORIZ POS control on the vectorscope so that the fall point of the
sync of the black burst signal is aligned to the center.
Align the fall point of
the sync to the center.
Using the Unit in a System UUNVUAUUUINIII
Adjusting the sync of the black burst signal
4 Output the player 1 signal from the editing control unit.
5 Press the A channel button on the vectorscope.
This displays the sync phase of the signal from player 1.
Align the fall point of
the sync to the center.
Adjusting the sync of the player 1 signal
7 Output the player 2 signal from the editing control unit.
Repeat steps 5 and 6 to align the fall point of the sync of the output signal from
player 2 to the center.
In this position, adjust the sync and subcarrier phases as follows.
34(E) Using the Unit in a System