Yamaha XSR900P Owner's Manual page 28

Instrument and control functions
position. To cancel the turn signal
1
lights, push the switch in after it has re-
turned to the center position.
2
Horn switch " "
3
Press this switch to sound the horn.
4
Stop/Run/Start switch "
5
To crank the engine with the starter, set
this switch to " ", and then push the
6
switch down towards " ". See page
7-2 for starting instructions prior to
starting the engine.
7
Set this switch to " " to stop the engine
in case of an emergency, such as when
8
the vehicle overturns or when the throt-
tle cable is stuck.
9
10
Hazard switch " "
Use this switch to turn on the hazard
11
lights (simultaneous flashing of all turn
signal lights). The hazard lights are
12 used in case of an emergency or to
warn other drivers when your vehicle is
stopped where it might be a traffic haz-
13
ard.
The hazard lights can be turned on or
off only when the key is in the "ON" po-
sition. You can turn the main switch to
the "OFF" or "LOCK" position, and the
hazard lights will continue to flash. To
EAU66030 turn off the hazard lights, turn the main
switch to the "ON" position and operate
the hazard switch again.
EAU66061
NOTICE
/ / "
Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
tery may discharge.
Cruise control switches
See page 4-1 for an explanation of the
cruise control system.
EAU91670
MODE switches
Use the MODE switches to change the
"D-MODE" and "TCS-MODE" located
on the left side of the main display.
There are three mode controls:
MODE up switch - press this switch to
change the selected mode setting up-
ward.
"MODE" switch - press this switch to
toggle left to right between "D-MODE"
and "TCS-MODE".
MODE down switch - press this switch
to change the selected mode setting
downward.
TIP

ECA10062

EAU73952

EAU91365



5-3
When in "D-MODE 1", pressing
the MODE up switch will cycle to
"D-MODE 4". When in "D-MODE
4", pressing the MODE down
switch will not cycle to "D-MODE
1".
The "TCS-MODE" can only be
turned off from the main display.
Select "TCS-MODE" with the
"MODE" switch, then press and
hold the MODE up switch until
"OFF" is displayed.
To turn the traction control system
back on, use the MODE down
switch.
When "TCS-MODE" has been set
to "OFF", the traction control sys-
tem, SCS and LIF systems are all
turned off together.
See page 5-10 for more informa-
tion on the MODE display.
See page 4-4 for more information