D-Mode - Yamaha XSR900P Owner's Manual

4 seconds, and then go off.
When not traveling with a set cruising
speed, if the start/engine stop switch is
set to the " " position, the engine
stalls, or the sidestand is lowered, then
the " " indicator light will go off (the
" " indicator light will not flash).
If the cruise control system is automati-
cally deactivated, please stop and con-
firm that your vehicle is in good
operating condition.
Before using the cruise control system
again, activate it using the power
switch.
TIP
In some cases, the cruise control sys-
tem may not be able to maintain the set
cruising speed when the vehicle is trav-
eling uphill or downhill.

When the vehicle is traveling up-
hill, the actual traveling speed may
become lower than the set cruising
speed. If this occurs, accelerate to
the desired traveling speed using
the throttle.

When the vehicle is traveling
downhill, the actual
speed may become higher than
the set cruising speed. If this oc-
curs, the setting switch cannot be
used to adjust the set cruising
speed. To reduce the traveling
speed, apply the brakes. When the
brakes are applied, the cruise con-
trol system will become deactivat-
ed.
traveling

"D-MODE"

"D-MODE" is an electronically con-
trolled engine performance system.
Do not change the drive mode while
the vehicle is moving.
The "D-MODE" system consists of 4
different control maps which regulate
engine response and output, thus pro-
viding you with a selection of modes to
fit your preferences and the riding envi-
ronment.
D-MODE 1 - Sporty engine response
D-MODE 2 - Moderate engine re-
sponse
D-MODE 3 - Mild engine response
D-MODE 4 - Mild engine response and
limits engine output
TIP



4-3
Special features
WARNING
The current "D-MODE" setting is
shown in the MODE display. (See
page 5-10.)
The current "D-MODE" setting is
saved when the vehicle is turned
off.
The "D-MODE" is controlled by the
EAU91323
1
2
EWA18440
3
4
5
6
7
8
9
10
11
12
13