CDA 3D9BL Manual For Installation, Use And Maintenance page 10

HOW
THE HOOD WORKS
SDD4 MODEL STAINLESS STEEL
AND GLASS VERSION (Fig. 17)
A: ÜT Light ON/OFF key
=
GLASS Version :
Lighting turns on and off independently from
the extractable unit position.
STAINLESS STEEL Version:
Lighting turns on and off only with the extract-
able unit open.
By pushing this key with the extractable unit
closed, the extractable unit will open and then
the lighting will turn on.
. UN
'OFF
With the appliance turned off:
The key starts the suctioning panel extraction
and, when it is fully open, activates the 2nd
speed of the motor.
ON/OFF key
With the suctioning panel open:
The key turns the motor off, turns the light-
ing off, if on, and draws back the suctioning
panel.
C: $ (-) Key
lt reduces the motor speed from the 4th
speed to complete turn off, without closing
the extractable unit.
D: 1 2 3 Y Indicators
e It shows the speed set by turning on only the
related led.
e lt signals the filters saturation by turning on
all leds.
e It shows the calibration reset by flashing all
of the leds.
GB
+
El
lt increases the motor speed from the 1st to
the 4th one, without moving the suctioning
panel.
E: (+) Key
(9 Timer
After 10 minutes from its setup, it allows to
stop the motor , close the extractable unit and
turn the lights off, if on.
This function is active when signaled by the
flashing of the "D" led related to the speed
setup.
Push the key again to annul this function.
Other functions:
Automatic turn off:
After 4 hours of continuous working from the
last setup, the appliance turns off and closes
automatically.
Grease filters saturation:
After 30 hours of working, the speed indica-
tors "D" will all flash simultaneously, signaling
the grease filters saturation.
To reset this alarm, push the "TIMER" key
when the downdraft is completely off and the
extractable unit is closed.
Calibration:
The cooker-hood carries out its self-calibra-
tion every 3 complete cycles of its extractable
unit.
By pushing the "TIMER" key 6 times consec-
utively (MAX break between one push and the
other is 3 sec.) all the leds will flash and the
calibration will be reset.
After the next 3 cycles the downaraft will carry
out its self-calibration.
".. πα