CDA 3D9BL Manual For Installation, Use And Maintenance page 9

ELECTRIAL HOOK UP
OF THE HOOD
ΔΝ WARNING ΔΝ
Place the metal box containing the elec-
tronic components at a distance of no less
than 65 cm from gas-operated cook tops or
in any case, 65 cm from the extraction point
of the hood.
ΔΝ ΝΟΤΑ ΔΝ
We recommend installing the metal box
containing the electronic components at
least 10 cm above floor level and at a suita-
ble distance from all heat sources (e.g. oven
sides or cook top).
ΔΝ CAUTION ΔΝ
This appliance is fitted with an HO5 VVF 3
conductor, 0.75 mm2 (neutral, phase, and
ground) power cable. This can be hooked
up to a 220 - 240 V mono-phase electrical
network by way of a CEI 60083 regulation
power socket that must remain accessible
after installation, in conformity to installa-
tion regulations.
We decline all responsibility in case of ac-
cident caused by a lack of ground connec-
tion or incorrect ground connection. The
appliance must be fed through a differen-
tial protection device (RCD), with a nominal
residual current not exceeding 30mA. If the
power cable is damaged, call the after-sales
service to avoid any risk.
ΔΝ WARNING ΔΝ
This appliance is fitted with an HO5 VVF 3
conductor, 0.75 mm2 (neutral, phase, and
ground) power cable. This can be hooked
up to a 220 - 240 V mono-phase electrical
network by way of a CEI 60083 regulation
power socket that must remain accessible
GB
after installation, in conformity to installa-
tion regulations.
A DANGER Δ
If the hood presents some form of anomaly,
unplug the appliance or remove the fuse
corresponding to the appliance's power
line.
If the appliance has no plug or if the plug is not
easily accessible, then a device needs to be fit-
ted to cut it off from the mains electricity; this
device must have an opening distance between
contacts on all poles of at least 3 mm.
ELECTRIAL HOOK UP
ΔΝ ΝΟΤΑ ΔΝ
This appliance conforms to the European
Directives 2006/95/EC (Low Voltage Direc-
tive) and 2004/108/EC (Electromagnetic
Compatibility).
When you install the appliance and carry out
maintenance, it must be unplugged from the
power source or the fuses must be disengaged
or removed. Electrical hook up must be carried
out before the appliance is installed in the cabi-
net.
Check that:
e the power source is sufficient,
* power cords are in good condition.
* The diameter of the cables conforms to
installation regulations.
A MA