Operation; Product Properties; Connecting To Use The Charging Modes; Disconnecting After Using The Charging Modes - ULTIMATE SPEED ULG 17 A1 Operation And Safety Notes Translation Of The Original Instructions

z Operation
Always unplug the mains plug from the socket before you perform any work at the
car battery charger or leave the device unattended.
RISK OF ELECTRIC SHOCK! DANGER OF PROPERTY DAMAGE! RISK OF INJURY!
z Product properties
This device is designed for charging many SLA batteries (sealed lead-acid batteries), which are used
primarily in cars, motorcycles and some other vehicles. They can be, e.g., WET (with liquid electrolyte),
GEL (with electrolyte gel) or AGM batteries (with electrolyte-absorbent mats). A special design of the
device (also called a "three-stage charging strategy") permits recharging of the battery to nearly 100%
of its capacity. The battery may also be permanently connected to the car battery charger in order to
keep it in optimal condition at all times. Furthermore, the battery charger has an integrated temperature
sensor in the device in order to safely recharge the battery even in cold weather (e.g. in the winter).
The device measures the ambient temperature and automatically sets the optimal charging voltage.
PLEASE NOTE: The ambient temperature is measured in the charger. Hence, for optimum function,
make sure the battery exhibits the same temperature as the environment.
z Connecting to use the charging modes
„
Disconnect the negative pole connection cable (black) of the vehicle from the negative pole of the
battery fi rst before charging and maintenance charging if the battery is continually connected in the
vehicle. The negative pole of your battery is usually connected to the car body of the vehicle.
„
Then disconnect the positive pole connection cable (red) of the vehicle from the positive pole of the
battery.
„
Only then connect the "+" pole quick-contact connection terminal (red)
to the "+" pole of the battery.
„
Connect the "–" pole quick-contact connection terminal (black)
Connect the mains cable
PLEASE NOTE: If the connection terminals are connected correctly, the digital display
the voltage and the "connected" display lights up. In the event of reverse polarity, the display will show
0.0 and the reverse polarity LED
z Disconnecting after using the charging modes
„
Disconnect the device from the mains current.
„
Disconnect the "–" pole quick-contact connection terminal (black)
„
Disconnect the "+" pole quick-contact connection terminal (red)
„
Reconnect the positive pole connection cable of the battery to the positive pole of the battery.
„
Reconnect the negative pole connection cable of the battery to the negative pole of the battery.
z Select charging mode and start charging process
You can choose from different charging modes to charge different batteries. As compared to conventional
car battery chargers, this device has a special function for reuse of a fl at battery/rechargeable battery.
You can recharge a completely discharged battery/rechargeable battery. Protection against wrong
connection and short circuit ensures safe charging. The integrated electronics do not start the car battery
charger at once after connection of the battery, but only after a charging mode has been selected.
of the car battery charger to the socket.
7
display l
will light up in red in the digital display
of the car battery charger
5
to the "–" pole of the battery.
4
.
6
from the "–" pole of the battery.
4
from the "+" pole of the battery.
5
indicates
6
GB 11