TP-Link Archer VX1800v User Manual page 34

Chapter 6
3. Choose your Telephony Provider
and click OK to make the settings effective.
4. If your telephony provider is not listed here, choose
information as required, and click
Phone Number: The number you use to dial and answer.
Registrar Address: Usually a domain name, if not, an IP address.
Authentication ID and
Advanced: Click to have more configuration.
To have more configuration on telephony settings
Click Advanced under
Bound Interface: Bound Interface decides where to send/receive the VoIP traffic. An
easy way to select the interface is to check the location of the SIP (Session Initiation
Protocol) server. If it locates somewhere on the internet then select Any_WAN. If it is on
the local network, select LAN.
Locale Selection: Select a country where you are located. The modem router is
embedded with some default parameters according to different countries such as ring
tones. The default country is Germany.
DSCP for SIP/RTP:
the ToS byte. DSCP marking allows users to assign specific application traffic to be
executed in priority by the next Router based on the DSCP value. Select DSCP for the
and enter the necessary information as required,
Save
Password: Not necessary information, but if you have, fill them in.
Advanced Settings
DSCP (Differentiated Services Code Point) is the first 6 bits in
Other
to make the settings effective.
to configure more telephony settings.
Telephony
provider, enter the
29