I N S TA L L AT I O N G U I D E L I N E S
POWER AND DATA CABLES
ENSURE ALL CONNECTIONS AND END-CAPS ARE PROPERLY SEALED WITH
DIELECTRIC GREASE (AVAILABLE AT MOST ELECTRICAL SUPPLIERS) TO PREVENT
WATER CORROSION AND/OR ELECTRICAL SHORT CIRCUIT.
TO MAINTAIN THE IP66 RATING INTEGRITY OF THE FIXTURE AND PREVENT WATER
FROM ENTERING THE FIXTURE, SEAL ALL UNUSED CONNECTION RUBBER CAPS.
BATTERY REPLACEMENT
Installing the battery incorrectly, in the wrong orientation, where the Plus
(+) is inside and Negative (-) is outside, will lead to internal electronics and
battery damage. A qualified electrician should be used for all electrical
connections and/or installations.
1. Loosen the screw cap for the battery compartment.
2. Remove old battery and replace (inside "-", and outside "+").
NOTE: Replace the battery only with an Li-ion battery (IRC14500/700mAh), which can be
ordered from the Elation Parts Website https://parts.elationlighting.com. Replace and
tighten screw cap for the battery compartment.
25