Elation PROTEUS HYBRID MAX User Manual page 18

C O LO R S A N D G O B O S
REPLACING A ROTATING GOBO
Place the fixture on a firm flat surface. Locate the (6x) screws on the side of the moving head
and remove them. With the panel set aside, locate the Pattern Bracket Assembly and remove
the (4x) screws that secure it to the internal housing frame.
Locate the (1x) screw on the side of the Pattern Bracket Assembly
Locate the specific Rotating Gobo to replace. Carefully grip the Gobo using your thumb and
index finger, gently lift it slightly, and then pull it out and away until it fully clears the Gobo
Wheel.
Locate the tab of the spring, and with a precision pick (or similar tool), carefully press the
retaining spring inward to relieve the tension. Remove the retaining spring and carefully
separate the GOBO from the GOBO Holder. Lastly, remove the flat washer attached to the
removed GOBO and attach it to the desired replacement GOBO. Install the replacemet Rotating
GOBO following the steps above in reverse order.
CAUTION: TAKE CARE NOT TO SCRATCH GOBO OR GOBO HOLDER
18