Assembling And Adjustments; Connect The Machine - Husqvarna DC 3300 Operator's Manual

ASSEMBLING AND ADJUSTMENTS

Connect the machine

General
NOTICE! Ensure vacuum is set to OFF position prior to
turning on power supply.
• The machine should be connected to an earthed outlet
socket. See instructions in the section "Operation".
Dry use
• Fit a plastic bag over the collection cone.
• Connect the grinder's hose from the tool to the vacuum
hose inlet on the machine.
• Connect the power plug to the outlet.
6 –
English
Operation (Slurry management)
CAUTION! It is strongly advisable that all
!
operators use a dust mask/respirator when
removing primary filter socks from the
machine.
The Husqvarna DC 3300 can also be used for collection of
wet materials such as slurry formed from the wet grinding
process.
In order to use the machine for slurry collection, simply
remove the primary filter socks from the unit.
• Release the two toggle latches and lift off the top unit.
• Tilt the entire silo unit backwards on it's rear wheels. Use
the rear handle to support unit while laying down.
• Open the dust flap and reach the fastening nut through the
dust collection cone.
• Detach the sock filter assembly from the agitator arm.
• Use a socket extension bar to reach in and unscrew the
agitor arm nyloc-nut. Take care of the nyloc-nut and
washer.