Senco TN41P1P Operating Instructions Manual page 5

Always place yourself in a firmly balanced position.
Stay alert, focus on your work and use common sense when using tool.
Keep bystanders and children away while operating tool.
Store idle tools out of the reach of minors or other untrained persons.
Drive fasteners into work surface only; never into materials too hard to penetrate.
Do not force tool. Let the tool do the work.
Use the correct tool for the application. The correct tool will do the job better and safer.
Tools shall be operated at the lowest pressure needed for the application. This will reduce noise levels, part wear, and
energy use.
Do not drive fasteners on top of other fasteners or with the tool at too steep of an angle; the fasteners can ricochet and
may cause injury.
When using tool, care should be taken due to possibility of tool recoil after a fastener is driven.
If safety element is unintentionally allowed to re-contact work surface following a recoil, an unwanted fastener will be
driven. Therefore, allow tool to recoil completely off work surface after a fastener is driven to avoid this condition.
Do not push safety element on work surface until a second fastener is desired.
Do not drive fasteners close to the edge of the work surface. Keep face and body parts away from tool and work sur-
face. The workpiece is likely to split and the fastener could fly free or ricochet and may cause injury.
2
1
Operating Controls
Do not use tool without danger label on tool. If label is missing, damaged or unreadable, contact your SENCO represen-
tative to obtain a new label.
Never use tool if safety element, trigger or springs have become inoperable, missing or damaged. Do not tamper with
or remove safety element, trigger or springs.
Disconnect tool from air before doing tool maintenance, clearing a jammed fastener, leaving work area, moving tool to
another location or handing the tool to another person, when not in use or outside of the operator's supervision.
Tools shall not be modified unless authorized in tool manual or approved in writing by manufacturer.
Use only parts, fasteners, and accessories recommended or sold by SENCO. Do not modify tool without authorization
from SENCO.
saFeTy WarNiNgs
Tool may eject a fastener when connected to air supply; therefore,
① remove all fasteners from tool
② before connecting air.
Do not load fasteners with trigger or workpiece contact element depressed.
Keep hands and body away from the fastener discharge area of tool near workpiece
contact.
Proper Power source
Use only clean, dry, regulated compressed air at recommended pressure.
Do not operate the tool with any alternate power source.
5