Configuration; To Set A Different Channel Of The Indoor Unit Infrared Signal Receiver - Daikin CTXM15A2V1B Installer's Reference Manual

10 |

Configuration

10 Configuration

10.1 To set a different channel of the indoor unit infrared signal receiver

Installer reference guide
46
In case 2 indoor units are installed in 1 room, you can change the channel for the
infrared signal receiver on the indoor unit to avoid the wireless remote control
signal confusion.
Prerequisite: Perform the following setting for only 1 of the units.
1 Remove the cover and the batteries from the remote control.
2 Cut the address jumper J4.
Address jumper J4
Factory setting (uncut)
After cutting with nippers
a Address jumper J4
NOTICE
Be careful NOT to damage any of the surrounding parts when cutting the address
jumper.
3 Turn the power supply on.
4 Press and
5 Press , select and press
Result: The Daikin eye will start to blink.
a Daikin eye
b Indoor unit ON/OFF switch
6 Press the indoor unit ON/OFF switch while the Daikin eye is blinking.
Address
1
2
simultaneously.
.
a
a
b
CTXM-A, FTXM-A, ATXM-A
Daikin room air conditioner
4P518023-17P – 2023.06