VTech HD100 User Manual page 3

Sip corded 1-line hotel telephone, sip corded 1-line wi-fi enabled hotel telephone
Table of Contents

Advertisement

adjustment of other controls may
result in damage and often requires
extensive work by an authorised
technician to restore the product to
normal operation.
• If the product has been dropped
and the telephone base and/or
handset has been damaged.
• If the product exhibits a distinct
change in performance.
15. Avoid using a telephone (other than
cordless) during an electrical storm.
There is a remote risk of electric shock
from lightning.
16. Do not use the telephone to report a
gas leak in the vicinity of the leak. Under
certain circumstances, a spark may be
created when the adapter is plugged
into the power outlet, or when the
handset is replaced in its cradle. This is
a common event associated with the
closing of any electrical circuit. The
user should not plug the phone into
a power outlet, and should not put a
charged handset into the cradle, if the
phone is located in an environment
containing concentrations of flammable
or flame-supporting gases, unless there
is adequate ventilation. A spark in such
an environment could create a fire or
explosion. Such environments might
include: medical use of oxygen without
adequate ventilation; industrial gases
(cleaning solvents; petrol vapours; etc.);
a leak of natural gas; etc.
17. Only put the handset of your telephone
next to your ear when it is in normal talk
mode.
18. The power adapters are intended to be
correctly oriented in a vertical or floor
mount position. The prongs are not
designed to hold the plug in place if it is
plugged into a ceiling, under-the-table
or cabinet outlet.
19. Use only the power cord and batteries
indicated in this manual. Do not dispose
of batteries in a fire. They may explode.
Check with local codes for possible
special disposal instructions.
20. In wall mounting position, make sure
to mount the telephone base on the
wall by aligning the eyelets with the
mounting studs of the wall plate. Then
slide the telephone base down on
both mounting studs until it locks into
place. Refer to the full instructions in
Installation in the user's manual.
21. This product should be mounted at a
height of less than 2 meters.
22. Listed PoE (The product is considered
not likely to require connection to an
Ethernet network with outside plant
routing)
.
CAUTIONS
• Keep small metallic objects such as pins
and staples away from the handset
receiver;
• For pluggable equipment, the socket
outlet (power adapter) shall be installed
near the equipment and shall be easily
accessible;
• The applied nameplate is located at the
bottom of the product;
• The equipment is only used for
mounting at heights < 2m.
SAVE THESE INSTRUCTIONS
EN - 3

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the HD100 and is the answer not in the manual?

This manual is also suitable for:

Sip seriesHd100w

Table of Contents