Table of Contents
Advertisement
Assembly
5.4 Installation
Table 5- 3
5.4.3
Machines with type of construction IM B15, IM B9, IM V8 and IM V9
Types of construction without bearings on the drive side
These machines do not have their own bearing system for the machine shaft at the drive end
(DE). The machine shaft is accepted by the (hollow) shaft or coupling of the system or driven
machine.
● Using the centering edge, the machine is aligned with respect to enclosures, flanges or
driven machines.
● Note that the temperature of the motor and motor shaft increases during operation. The
thermal expansion of the machine shaft must be compensated by the customer by
applying suitable measures.
Use the spring washers provided to locate the NDE bearing without any play.
NOTICE
Damage to the motor
Material damage can occur if the following notes are not carefully observed:
• The IM B3 bearing shield with built-in distance ring mounted at the DE is only used as
• The spacer ring is not a roller bearing.
• Remove the bearing shield and the spacer ring.
• Remove the transport lock before commissioning.
40
Minimum dimension "X" for the distance between neighboring modules and the air intake
on machines
Frame size
80 ... 100
112
132
160
180 ... 225
280 ... 315
transport lock. A warning label is attached to this bearing shield.
X
[mm]
20
25
30
40
45
110
Smoke extraction motors
Operating Instructions, 03/2016, 5 610 80000 40 018
Advertisement
Table of Contents
