Electric Safety Requirement; Functions & Features - intensity IDCES180KF-5 Owner's Manual

Do not operate the air conditioner with a wet hand.
An electric shock may happen.
Do not touch the heat exchanger fins.
These fins are sharp and could result in cutting injuries.
Do not place items which might be damaged by moisture
under the indoor unit.
Condensation may form if the humidity is above 80%, the
drain outlet is blocked or the filter is polluted.
After a long use, check the unit stand and fitting for
damage.
If damaged, the unit may fall and result in injury.
To avoid oxygen deficiency, ventilate the room
sufficiently if equipment with burner is used together
with the air conditioner.
Arrange the drain hose to ensure smooth drainage.
Incomplete drainage may cause wetting of the building,
furniture etc.
Never touch the internal parts of the controller.
Do not remove the front panel. Some parts inside are
dangerous to touch, and a machine trouble may happen.
Never expose little children, plants or animals directly to
the air flow.
Adverse influence to little children, animals and plants may
result.
Do not allow a child to mount on the outdoor unit or
avoid placing any object on it.
Falling or tumbling may result in injury.
Do not operate the air conditioner when using a room
fumigation - type insecticide.
Failure to observe could cause the chemicals to become
deposited in the unit, which could endanger the health of
those who are hypersensitive to chemicals.
Do not place appliances which produce open fire in
places exposed to the air flow from the unit or under the
indoor unit.
It may cause incomplete combustion or deformation of the
unit due to the heat.
Do not install the air conditioner at any place where
flammable gas may leak out.
If the gas leaks out and stays around the air conditioner, a
fire may break out.
The appliance is not intended for use by young children
or infirm persons without supervision.
DISPOSAL：Do not dispose this product as unsor-
ted municipal waste. Collection of such waste sepa-
rately for special treatment is necessary.

2. ELECTRIC SAFETY REQUIREMENT

Wire distribution must be performed by duly qualified electricians.
All wire distribution must comply with electric safety specifications.
Ensure that the air coditioner is grounded properly. Namely, the
main switch of the air conditioner must have reliable ground wires.
owner's manual
2
Provide the air conditioner with a separate power supply compliant
with the nominal parameter values.
Electric performance requirements:
Table.2-1(Duct type)
Power supply
Capacity
7.5
Outdoor unit
15
Indoor unit
Outdoor unit 10
Indoor unit
20
Do not cut off the ground wire of the main power switch in any
circumstance.
Do not use damaged power wires. Change the damaged power
wires once they are detected.
Connect the power supply of the air conditioner for preheating it
for at least 12 hours before using the air conditioner. Besides
that, please be keep in mind that do not cut off the power supply
immediately, for the unit completely shut down needs to spend a
day-night.( In order to prevent the compressor drive-up by
forced, then heating the crankcase.)
Do not block the air inlet and outlet, if that so the performance
would reduce and the unit couldn't be start for which protect
device is on service.
3. FUNCTIONS & FEATURES
3.1 Duct type
Nested in the ceiling, space-saving and noble.
High capacity of cooling/heating, efficient, and energy-saving.
Innovative air supply, which provides homogeneous condition-
ing of the room temperature.
Remote control or wire control function.
Low noise design.
The air outlet is laid out in the way you desire.
Use refrigerant to transmit cool/heat directly, which provides a
high transmitting efficiency.
It is suitable be used for office, hospital, commerical place and
home, the air conditioner will creat the comfortable and
elegance enviroment for you.
The main switch
specification specification
208-230V 3N~ 60Hz 70A
208~230V 60Hz 20A
208-230V 3N~ 60Hz 100A
208~230V 60Hz 40A
NOTE
Fuse
50A
8A
70A
20A