Assembly - Sears PRO-FORM 580si User Manual

ASSEMBLY
Two people are required for assembly. Set the treadmill in a cleared area and remove all packing materials.
Do not dispose of the packing materials until assembly is completed. Assembly requires the included 7/32"
allen wrench _ and your own phillips screwdriver _ .
1. Firmly hold one of the Uprights (6, 88) with both hands.
Raise the Uprights until the Front Wheels (58) are resting
on the floor. The inset drawing shows how the treadmill
should appear when this step is completed.
88
.
Loosen the Crossbar Bolts (1) in the ends of the Console
Crossbar (9). Pivot the Console (10) to the angle shown.
Look under the Left and Right Console Brackets (3, 36)
and find the two small holes in each end of the Console
Crossbar (9). Tighten Crossbar Screws (84) into all four
holes.
Pivot the Console (10) upward until it stops. Using the
7/32" Allen Wrench (89), tighten the Crossbar Bolts (1).
2
6
3. Remove the paper bacldng from the Adhesive Clip (26).
Press the Adhesive Clip onto the Frame (49) in the indi-
cated IooatJon.Press the 3/16" Allen Wrench (83) into the
Adhesive Clip. The use of the 3/16" Allen Wrench is de-
scribed on pages 12and 13.
Make sure that all parts am tightened before you use the
treadmill. Note: To protect the floor or carpet from darn-
age, place a mat under the treadmill
49