Descaling Cycle - Espresso Machine - Sunbeam EMM7300 User Manual

Descaling cycle – Espresso machine
After continued use, your Origins Espresso
Machine may develop a build-up of mineral
deposits and therefore require occasional
descaling.
We recommend descaling your Origins
Espresso Machine every 4-6 months,
although this period will depend on the
hardness of water and frequency of use.
Descaling Solution
You have 2 options:
A. Sunbeam Espresso Machine Descaling
Tablets.
or
B. White vinegar & warm water.
Descaling Cycle
The Descaling Cycle takes approximately
10 minutes to complete.
Important: If the Descaling Cycle is not
completed or stopped part way through
any of the Descaling Steps, then you will
need to start the Descaling Cycle again
from the beginning.
Preparing for Descaling Cycle
- Remove water filter and water filter
holder from the water reservoir.
• Fill Water Reservoir with Solution
A. Fill Water Reservoir with 1 Litre of warm
water. Add one Descaling Tablet. Allow
tablet to fully dissolve.
or
B. In an empty Water Reservoir add 1½
tablespoons of white vinegar. Fill Water
Reservoir with 1 Litre of warm water. Allow
solution to mix thoroughly.
- Insert the Water Reservoir into position.
- Place a 1 Litre container under the
Group Head and the hot water tap.
• Check Power
Ensure that:
- The Power Plug is inserted into the outlet
& switched on.
- The DIAL is in the vertical position.
- The Origins Espresso Machine
is on and in the READY state.
• Access the Descaling Cycle
Simultaneously press & hold
the Manual Brew and Single
shot brew buttons for 3
seconds. The Origins Espresso
Machine will beep 3 times and
the clean/descale icon will
begin to pulse.
- The descale icon will Pulse throughout
the duration of the Descaling cycle.
1L
1L
37