Sunbeam EMM7300 User Manual page 35

Care and cleaning – Grinder
- Reset to the Grind Setting noted prior to
cleaning.
Cleaning & Unblocking Grinder Burrs,
Collar, Grind Chamber and Outlet
• 1-2 Months
If the Grinder is used frequently (everyday),
the Burrs need to be cleaned to ensure
best performance of the integrated Grinder.
Regular cleaning helps the Burrs achieve
consistent grinding results, which is
especially important when grinding coffee
beans for espresso.
• Preparing to Clean
- Turn off the machine, switch off and
unplug at power outlet.
CAUTION: Care should be taken when
cleaning Grinder Burrs as they are sharp.
• Grind Off Excess Coffee Beans
- The machine is on and in the READY
state.
- Make note of the current Grind Setting (to
use as the starting point after cleaning).
- Insert Two Cup Filter Basket into the
Group Handle.
- Insert Group Handle into Grinding Cradle.
TWO CUP
- Turn Bean Hopper fully anti-clockwise to
close the Hopper Gates and unlock the
Bean Hopper. The Bean Hopper will pop
up slightly.
- Remove the Bean Hopper from the
Grinder Collar and store any remaining
coffee beans in an airtight container to
preserve their freshness.
2. REMOVE
1. TURN
- Reinstall the bean hopper and rotate
to setting 30. Push down on the Group
Handle to activate the grinder, and hold
until the remain beans are ground and
dispensed (you will hear the sound of the
motor change).
- Rotate and remove the bean hopper again
- Remove the Group Handle and dispose
of the waste grinds as these will be too
coarse for espresso coffee.
• Cleaning Top Burr
- Rotate to unlock and lift the Top Burr
from the Grinder Collar using the handle.
- Wash the Top Burr in warm soapy water
with a mild detergent, rinse & dry.
AIR TIGHT
CONTAINER
35