Installation - Graco A Series Instructions-Parts List Manual

INSTALLATION
Check for Shipping Damage
The Commander should be checked for any damage
which comes wrih unit or bend connecting prongs to fit
an improper outlet!
li
you use an extension cord, it must
that may have occurred in shipping. Any damage
should
be.^ n o t e d a n d t h e c a r r i e r n o t i f i e d
have 4 wires of at least 12 gauge and should not be over
immediately.
1 0 0 h long. Added length of cord will affect current draw
of unit.
Check Electrical Service and Plug In
Before plugging in the sprayer, be sure the electrical
Install Hose and Spray Gun
service is 230 V,
60
HZAC
20 Amp, three phase and
outlet is properly grounded. With the
ON-OFF switch
Connect the spray hose to the spray gun by inserting
the pin fitting a t the end of the hose into the quick
in the
OFF
position, plug the power supply
cord into a
grounded outlet. Do not remove the electrical plug
disconnect coupler
on
the gun. Connect the hose to
the fluid outlet
on
the front of the unit.
PUMP "ON"
INDICATOR LIGHT
4
803-010