Advertisement
These quick s etup p ages will p rovide you, inthree e asy s teps, with the basic i nformation
you
need t obegin u sing y our new television
right away.
Ifyou have q uestions,
orformore d etailed information
onany ofthese s teps, please consult
other sections ofthis manual.
Before you can operate your remote control, you first n eed t oinstall the batteries
(included).
Lift a nd pull t he latch o nthe back o fthe remote
control toopen. Insert two batteries
(included)
carefully
noting the "+" a nd "-"markings,
placing
the "-"end inthe unit f irst. Snap t he cover back
into place.
When y ou
change the batteries, try to
complete the task within three minutes. If you
take longer than three minutes, the remote
O
control codes for your VCR, DVD, and/or
cable box/satellite
receiver may have to be
reset. See pages 25 - 28.
Key Feature
Buttons
The four key feature buttons at the center of the remote can be
used for basic operation of the television. The top and bottom
buttons will scan forward and back through the available
channels. To move rapidly through the channels using
JVC's Hyperscan
feature, press and hold CH+ or CH-. The
channels will zip by at a rate of five channels per second. The
right and left buttons will turn the volume up or down. These
buttons are also marked with four arrows and are used with
JVC's onscreen menu system. To use the onscreen menus,
press the MENUbutton.
Basic Operation
Turn the television on and off by pressing the POWERbutton at the top right corner
of the remote. If this is the first time you are turning on the TV, the interactive
plug-in menu appears.
• Make sure the TV/CATV switch is set to TV. Move the switch to CATV only if
you need to operate a cable box.
• Slide the VCR/DVD
selector switch to VCR to control a VCR. Slide to
DVD to control a DVD player. Please see pages 25 to 28 for instructions on
programming
your remote control to operate a cable box, VCR or DVD player.
Advertisement
