Advertisement
Connecting
to JVC AV Compu Link
JVC's AV CompuLink
feature makes playing video tapes or DVDs totally automatic. Simply
insert a pre-recorded
tape into your JVC brand VCR or DVD into your JVC DVD player and
the device will automatically
turn on and begin playback. At the same time, using the
AV CompuLink.
the VCR or DVD player sends a signal to the television telling it to turn on
and switch to the proper video input.
• The AV CompuLink
cable may be included with the JVC AV CompuLink
unit you
wish to connect. If it is not. contact JVC Parts Department
at (800)-882-2345.
or
www.jvcservice.com
for part # EWP 805-012.
• AV CompuLink
can only be used with JVC brand products.
AV CompuLink
Cable
To Connect:
Plug one end of the AV CompuLink
cable
into the AV COMPULINK
INPUT on your VCR, DVD,
or other CompuLink device. Plug the other end of the
AV CompuLink
cable into the AV COMPULINK
at the
rear of the television.
Note:
• The AV CompuLink
cable has a male 3.5 mm (mono)
plug on each end.
TV Rear Panel
•
v
L R
-_
_} _}OUT
AV CompuLink
VCR
Notes:
• In order for the VCR playback to begin automatically,
the recording tabs must be removed
from the VHS tape. If the tab is in place, automatic switching will occur when you push the
VCR's
PLAY
button.
• If your JVC brand VCR has "Acode/B
code remote control switching" (see your VCR's
instruction book), using VCRA
code will switch the TV to input 1.
• Refer to your DVD instruction book for detailed connection information.
• To connect a JVC HiFi receiver or amplifier for a completely
automated
home theater, see
the receiver connection instructions
for detailed connection information.
• AV CompuLink is compatible with select AV CompuLink
receivers.
Advertisement
