KTM 390 DUKE 2024 Owner's Manual page 58

9 RIDING INSTRUCTIONS
Note
Engine failure Overheating damages the engine.
–
If the coolant temperature warning is displayed, stop immediately and take care not to endanger yourself or
other traffic participants in the process.
–
Allow the engine and cooling system to cool down.
–
Check and, if necessary, correct the coolant level on the cooling system while it is in a cooled state.
Note
Transmission damage Incorrect use of the QUICKSHIFTER+ will damage the transmission.
The QUICKSHIFTER+ can only be used if the function is enabled in the combination instrument.
The QUICKSHIFTER+ is not active if you pull the clutch lever.
–
Only use the QUICKSHIFTER+ in the permitted speed range shown.
56
Warning
Danger of accidents Cold tires have reduced road grip.
–
Ride the first miles carefully on every journey at moderate speed until the tires reach operating tem-
perature.
Warning
Danger of accidents New tires have reduced road grip.
The contact surface on new tires is not yet roughened.
–
Run in new tires with moderate riding and only gradually increase the lean angle.
Run-in distance
Warning
Danger of accidents Improper mounting of cases, tank rucksacks or other luggage impairs the handling
characteristics.
Luggage mounted incorrectly can slip while the vehicle is in motion.
–
Mount and secure all luggage according to the manufacturer's instructions.
–
Check that your luggage is fixed properly at regular intervals.
Warning
Danger of accidents A fall can damage the vehicle more seriously than it may first appear.
–
Check the vehicle after a fall as you do when preparing for use.
Info
If unusual noises occur while riding, stop immediately (taking care not to endanger yourself or other road
users in the process), switch off the engine and contact an authorized KTM workshop.
401950-11
200 km (124 mi)
–
Shift into a higher gear when conditions allow (incline, road
situation, etc.).
–
Release the throttle while simultaneously pulling the clutch
lever, shift into the next gear, release the clutch lever, and
open the throttle.
Info
The gear positions can be seen in the figure. The idle
position is between the first and second gears. First
gear is used for starting off or for steep inclines.
–
After reaching maximum speed by fully opening the throttle
grip, turn the throttle back so it is ¾ open. This will barely