Port Mirror - TRENDnet TI-BG62i User Manual

6-port industrial gigabit l2+ managed poe++ din-rail switch
Table of Contents

Advertisement

TRENDnet User's Guide
Parameter
Description
Select Enable from the drop down box to enable Link
Aggregation Control Protocol (LACP).
State
Select Disable to not use LACP.
System Priority
LACP system priority is a number between 1 and 65,535. The
switch with the lowest system priority (and lowest port number
if system priority is the same) becomes the LACP "server". The
LACP "server" controls the operation of LACP setup. Enter a
number to set the priority of an active port using Link
Aggregation Control Protocol (LACP). The smaller the number,
the higher the priority level.
Group LACP
Select a trunk group ID and then select whether to Enable or
Disable Group Link Aggregation Control Protocol for that trunk
group.
© Copyright 2023 TRENDnet. All Rights Reserved.
Port Priority
Select a port or a range of ports to configure its (their) LACP
priority.
Apply
Click Apply to configure the settings.
Refresh
Click this to reset the fields to the last setting.
LACP Group Status
Group ID
The field identifies the LACP group ID.
LACP State
This field displays if the group has LACP enabled.
LACP Group Status
Port
The field identifies the port ID.
Priority
The field identifies the port's LACP priority.

Port Mirror

Port-based Mirroring
The Port-Based Mirroring is used on a network switch to send a copy of network packets
sent/received on one or a range of switch ports to a network monitoring connection on
another switch port (Monitor to Port). This is commonly used for network appliances that
require monitoring of network traffic, such as an intrusion-detection system.
Port Mirroring, together with a network traffic analyzer, helps to monitor network traffic.
Users can monitor the selected ports (Source Ports) for egress and/or ingress packets.
Source Mode:
Ingress : The received packets will be copied to the monitor port.
Egress : The transmitted packets will be copied to the monitor port.
Both
: The received and transmitted packets will be copied to the monitor
port.
Note:
TI-BG62i
59

Advertisement

Table of Contents
loading

Table of Contents