Table of Contents
Advertisement
1. Lynch pins
Note:
The aerator can be stored on the original
shipping pallet.
6.
Slowly lower the aerator until the storage stands
contact the ground.
7.
Loosen the locking nut and rotate the upper
adjusting link to release the tension between the
aerator and the tractor.
8.
Remove the lynch pin and the top link pin
securing the center link to the bracket. Retain
the lynch pin and the top link pin with the aerator.
9.
Disconnect the safety shield chains from the
tractor PTO (CE only).
10.
Pull back on the lock collar to disconnect the
power shaft from the tractor PTO shaft.
11.
Slide the PTO shaft back and remove it from
the tractor.
12.
Connect the PTO tether to the PTO shield to
prevent the PTO shaft from contacting the
ground
(Figure
45).
Figure 44
2. Storage stand
1. PTO tether
13.
Remove the lynch pins and slide the lower link
arms off the hitch pins. Retain the lynch pins
with the aerator.
g007302
33
Figure 45
g007307
Advertisement
Table of Contents
