Table of Contents
Advertisement
ON PARAMETERS
E. REL. T. (Early Reflection Time)
The time required for the early reflections to reach the listener.
E. RFL. L. (Early Reflection Level)
The intensity of the early reflections.
REV. T. (Reverberation Time)
PRE. DT (Pre-Delay Time)
The interval between the direct sound arrival and the start of
reverberation.
RT HIGH (Rotate High)
Direct sound arrival
Early reflections
Reverberation
Level
1
Time
Eee T
RT HIGH
PRE. DT
REV. T.
Basic parameters for reverberation effect
SPREAD
This parameter defines the width of the sound stage.
It controls the time required for each single reflection to reach
the listener.
PHASE
Determines the phase relationship of the early reflections and
the feedback signal. When E. RFL. L. and FBL are set to
negative values, the phase is reversed.
FBL
Determines at which ratio the repeat output is fed back to the
input for delay effect in modes 5, 6 and 9 (channel 2).
REPEAT
Determines the number of repeat output signals for the delay
effect in mode 5 and mode 9 (channel 2). Depending on the
REV. T. value, a maximum of 20 repeats can be selected.
GATE T. (Gate Time)
Determines the interval between start of reverberation and cut
of reverberation by the gate circuit. Used for gate reverb of
mode 3 and mode 8 (channel 2), and for reverse reverbin mode
4.
DEPTH
Determines the panning depth for auto-pan of mode 6
SPEED
Determines the panning speed for auto-pan of mode 6
100 Hz, +12 dB
© L MID (LOW Mid) ..e.sssssesssssssssessseccccsesssseseeesenees 400 Hz +12 dB
©H MID (High Mid) .......cscsssssssssecssssssscseeseeseseees 1.6 kHz +12 dB
IAEA
pccarcegch cect eink earscadednemomeneateats 6.4 kHz +12 dB
The parameters of the two-channel, four-band equalizer can be
adjusted at the respective center frequencies over a range of
+12 dB in 2-dB steps.
EFF. L (Effect Level)
Serves to preset the output level that is produced whentme
EFFECT control is at maximum.
CASCADE
Permits cascade (serial) connection of effects produce jz
channel 1 and channel 2. This function uses digital sigia #
processing and is available in modes 8 and 9.
Advertisement
Table of Contents
