Jtag Connector - Ublox XPLR-HPG-2 User Manual

4.1.4

JTAG connector

The bottom side of the C214 board includes the footprint for a 10-pin 0.05" pitch JTAG connector
(J11), as shown in
Figure 14: JTAG Enable solder jumper and 10-pin JTAG footprint
Four of these connectors are shared with the cellular modem as part of the 8-pin UART connections,
as shown in Figure 15.
☞
JTAG connector (J11) is a 2x5 position SMD pin header with 1.27 mm pitch. The connector is not
mounted on the C214 board standard version but can be added if needed.
Figure 15: JTAG connector (J11) pinout
UBX-23003719 - R02
C1-Public
Figure 14.
Module configuration
XPLR-HPG-2 - User guide
Page 21 of 32